Handyman Services in Austin, TX

Interior carpentry is one of the most common categories of repair work in Austin homes, particularly in older neighborhoods where wood trim has settled, warped, or been damaged over time. We handle baseboard installation and repair, door casing replacement, window trim adjustments, crown molding touch-ups, and custom wood patching. Work is measured and cut precisely before installation to ensure tight, clean joints without gaps or visible seams. All nails are set and filled; painted surfaces receive a finish-ready skim coat before handoff.

Drywall damage is one of the most frequent requests we receive — from small nail holes to larger sections damaged by water, impact, or plumbing access. We use California patches or backer-board methods depending on the size of the damaged area, apply joint compound in the appropriate number of coats, and sand progressively to achieve a smooth surface that accepts paint without visible ridges or texture differences. Austin's humidity and heat cycles affect how drywall mud cures, and we factor that into our timing and finishing approach. Texture matching is available for walls with orange peel or knockdown finishes.

We install a wide range of residential fixtures including ceiling fans, light fixtures, bathroom accessories (towel bars, grab bars, toilet paper holders), kitchen hardware, door hardware, and cabinet pulls and knobs. All fixture installations are checked for level and secure mounting before completion. For ceiling-mounted fixtures, we verify that electrical boxes are rated for the fan or fixture weight being installed. We do not perform panel work or full rewiring — fixture-level installation and replacement only.

Doors and windows in Austin homes are frequently affected by the region's expansive clay soils, which cause foundation movement and seasonal shifting. We diagnose and correct sticking doors by planing or sanding edges, adjusting hinges, and resetting strike plates. Window adjustments include sash repairs, balance replacements on double-hung windows, weatherstripping installation, and hardware replacement. We also install door sweeps, threshold seals, and frame reinforcement where needed. Proper door and window function also improves energy efficiency and reduces HVAC load in Austin's climate.

Outdoor wood structures in central Texas take significant weathering from UV exposure, humidity, and temperature swings. We perform deck board replacement, railing repairs, post stabilization, and fastener replacement on existing deck structures. Fence work includes board replacement, post resetting, gate hinge and latch repair, and picket replacement. We use appropriate exterior-grade fasteners and hardware rated for outdoor use. Surfaces are checked for structural integrity before cosmetic repairs to ensure the finished work is sound, not just presentable.

Proper sealing at penetrations, transitions, and exterior joints is critical in Austin given the temperature extremes and occasional heavy rainfall. We re-caulk tubs, showers, sinks, and countertops using mold-resistant silicone or urethane-based sealants selected for the surface type. Exterior caulking at window and door frames, siding transitions, and penetrations is done with paintable polyurethane sealants rated for UV and temperature cycling. Old caulk is fully removed and surfaces cleaned before new material is applied — we don't caulk over deteriorated sealant.

We handle the minor plumbing and electrical tasks that fall below the threshold requiring a licensed specialist — faucet replacement, supply line replacement, shut-off valve swaps, toilet flapper and fill valve replacement, drain clearing, and fixture swaps. On the electrical side: switch and outlet replacement, light fixture and fan swaps, and GFCI outlet installation in kitchens and bathrooms. We do not perform work that requires permits, panel modifications, or structural plumbing changes. When a job exceeds that scope, we say so clearly and can recommend appropriate tradespeople in the Austin area.

Interior and exterior painting for residential clients across Austin. We prep surfaces properly — filling holes, sanding, priming bare or patched areas — before applying finish coats. Paint is rolled in overlapping sections with a consistent technique to avoid lap marks. Trim and cut-in work is done with a brush for clean, defined edges. We match existing paint sheens where possible and can coordinate color selection if needed. Work areas are protected with drop cloths and tape, and cleanup is complete before we leave.